Handler 125 vs IronMan 240

Same fields. Each cell is that model's published text. A blank stays "Not published by manufacturer." The outlet chip does not hide either column.

Spec	Handler 125	IronMan 240
Process	Flux-cored out of the box, and MIG after a regulator and shielding gas are added. The sheet calls it a constant-voltage DC welder. Source	MIG and flux-cored. Spool-gun connection is described for aluminum wire. Source
Output amp range	25–130 A. Source	30–280 A. Source
Rated duty cycle	80 A at 25% duty cycle. The specifications table also prints 50 A at 60% and 40 A at 100%. Source	200 A at 24 VDC, 60% duty cycle. Source
Input voltage and plug	120 V. Amps input at rated output, 60 Hz: 21.3 A. The sheet says it operates on common 120-volt power and includes a power cord with plug. It does not name the plug or a breaker size. Source	208 V and 240 V. Amperes input at rated load: 57.0 A at 208 V and 50.8 A at 240 V, on the 200 A, 60% row. A power cord with plug is included. The plug is not named. Source
Wire or rod size	Ready to weld with .030–.035 in. (0.8–0.9 mm) self-shielding flux-cored wire. With gas, .023–.030 in. (0.6–0.8 mm) solid wire. Stainless wire is mentioned for 18–12 gauge stainless with tri-mix gas. Source	The gun note on the sheet says .023–.045 in. (0.6–1.1 mm) wire, and the included drive roll is a dual-groove .030/.035 in. roll. Wire feed speed is 50–700 ipm. Source
Weight	57.5 lb. Source	186 lb. Source
Material thickness	Mild steel thickness range 24 ga.–3/16 in. The same page limits the gas-shielded example to 24 gauge–1/8 inch steel. Source	Mild steel thickness range 24 ga.–1/2 in. (13 mm). Source