Handler 125 vs Power MIG 260

Same fields. Each cell is that model's published text. A blank stays "Not published by manufacturer." The outlet chip does not hide either column.

Spec	Handler 125	Power MIG 260
Process	Flux-cored out of the box, and MIG after a regulator and shielding gas are added. The sheet calls it a constant-voltage DC welder. Source	MIG and flux-cored. Source
Output amp range	25–130 A. Source	30–300 A. Wire feed speed 50–700 ipm (1.3–17.7 m/min). Source
Rated duty cycle	80 A at 25% duty cycle. The specifications table also prints 50 A at 60% and 40 A at 100%. Source	250 A / 26.5 V / 40%. Source
Input voltage and plug	120 V. Amps input at rated output, 60 Hz: 21.3 A. The sheet says it operates on common 120-volt power and includes a power cord with plug. It does not name the plug or a breaker size. Source	208/230/460/575 V, 1-phase, 60 Hz. Input current at rated output: 59/55/27/21 A in that voltage order. The 230 V figure is 55 A. This check treats that 230 V figure as the 240 V outlet class. Source
Wire or rod size	Ready to weld with .030–.035 in. (0.8–0.9 mm) self-shielding flux-cored wire. With gas, .023–.030 in. (0.6–0.8 mm) solid wire. Stainless wire is mentioned for 18–12 gauge stainless with tri-mix gas. Source	Not published by manufacturer Source
Weight	57.5 lb. Source	247 lb (112 kg). Dimensions 37.3 x 18 x 40.4 in. Source
Material thickness	Mild steel thickness range 24 ga.–3/16 in. The same page limits the gas-shielded example to 24 gauge–1/8 inch steel. Source	Not published by manufacturer Source