Handler 125 vs TIG230

Same fields. Each cell is that model's published text. A blank stays "Not published by manufacturer." The outlet chip does not hide either column.

Spec	Handler 125	TIG230
Process	Flux-cored out of the box, and MIG after a regulator and shielding gas are added. The sheet calls it a constant-voltage DC welder. Source	AC/DC TIG and stick. The page lists nine AC waveforms, including square, sine, triangle, and hybrid. Source
Output amp range	25–130 A. Source	TIG 2–230 A. Stick 10–200 A. Source
Rated duty cycle	80 A at 25% duty cycle. The specifications table also prints 50 A at 60% and 40 A at 100%. Source	TIG: 35% at 230 A, 60% at 175 A, 100% at 136 A. Stick: 35% at 200 A, 60% at 152 A, 100% at 118 A. The duty lines are not split by voltage. Source
Input voltage and plug	120 V. Amps input at rated output, 60 Hz: 21.3 A. The sheet says it operates on common 120-volt power and includes a power cord with plug. It does not name the plug or a breaker size. Source	90–275 V, 50–60 Hz. That range covers a 120 V outlet and a 240 V outlet. Input amperes are not in the specifications block. Source
Wire or rod size	Ready to weld with .030–.035 in. (0.8–0.9 mm) self-shielding flux-cored wire. With gas, .023–.030 in. (0.6–0.8 mm) solid wire. Stainless wire is mentioned for 18–12 gauge stainless with tri-mix gas. Source	Not published by manufacturer Source
Weight	57.5 lb. Source	46 lb. Dimensions 22 in. long, 8 in. wide, 16 in. high. Source
Material thickness	Mild steel thickness range 24 ga.–3/16 in. The same page limits the gas-shielded example to 24 gauge–1/8 inch steel. Source	Not published by manufacturer Source