Handler 125 vs TIG325X

Same fields. Each cell is that model's published text. A blank stays "Not published by manufacturer." The outlet chip does not hide either column.

Spec	Handler 125	TIG325X
Process	Flux-cored out of the box, and MIG after a regulator and shielding gas are added. The sheet calls it a constant-voltage DC welder. Source	AC/DC TIG and stick. The output line splits TIG into 5–325 A DC and 10–325 A AC. Source
Output amp range	25–130 A. Source	TIG 10–325 A (5–325 A DC, 10–325 A AC). Stick 20–250 A. Source
Rated duty cycle	80 A at 25% duty cycle. The specifications table also prints 50 A at 60% and 40 A at 100%. Source	TIG: 40% at 325 A, 60% at 280 A, 100% at 250 A. Stick: 40% at 250 A, 60% at 220 A, 100% at 180 A. The duty lines are not split by voltage. Source
Input voltage and plug	120 V. Amps input at rated output, 60 Hz: 21.3 A. The sheet says it operates on common 120-volt power and includes a power cord with plug. It does not name the plug or a breaker size. Source	120 V / 240 V, single-phase, 50/60 Hz. Input amperes are not in the specifications list. Source
Wire or rod size	Ready to weld with .030–.035 in. (0.8–0.9 mm) self-shielding flux-cored wire. With gas, .023–.030 in. (0.6–0.8 mm) solid wire. Stainless wire is mentioned for 18–12 gauge stainless with tri-mix gas. Source	Not published by manufacturer Source
Weight	57.5 lb. Source	73.24 lb (about 33.2 kg). Source
Material thickness	Mild steel thickness range 24 ga.–3/16 in. The same page limits the gas-shielded example to 24 gauge–1/8 inch steel. Source	Not published by manufacturer Source