Home CompareMillermatic 142 vs Multi-Handler 200
Millermatic 142 vs Multi-Handler 200
Same fields. Each cell is that model's published text. A blank stays "Not published by manufacturer." The outlet chip does not hide either column.
| Spec | Millermatic 142 | Multi-Handler 200 |
|---|---|---|
| Process | MIG (GMAW) and flux-cored (FCAW). | MIG, flux-cored, DC TIG, and stick. |
| Output amp range | 30–140 A. | MIG/flux-cored: 30–200 A. DC TIG: 20–200 A. Stick: 30–200 A. The table narrows 120 V MIG to 30–120 A, 120 V TIG to 20–140 A, and 120 V stick to 30–100 A. |
| Rated duty cycle | 100 A at 19 V, 60% duty cycle. 80 A at 18 V, 100% duty cycle. | At 30% duty cycle: MIG 110 A at 19.5 V on 120 V and 165 A at 22.2 V on 240 V; DC TIG 105 A at 14.2 V on 120 V and 165 A at 16.6 V on 240 V; stick 90 A at 23.6 V on 120 V and 140 A at 25.6 V on 240 V. |
| Input voltage and plug | 120 V, 20 A, single-phase, 50/60 Hz. | 120 V or 240 V, 50/60 Hz. MVP plugs: 5-15P (120 V, 15 A) and 6-50P (240 V, 50 A). Amps input at rated output, MIG: 23.0 A at 120 V and 19.0 A at 240 V. DC TIG: 16.7 A and 14.7 A. Stick: 22.0 A and 17.9 A. |
| Wire or rod size | Set up for .024–.035 in. (0.6–0.9 mm) solid wire and .030–.045 in. (0.8–1.2 mm) flux-cored wire. Uses 4- or 8-inch spools. | Quick Select drive roll for .024 in. (0.6 mm) or .030/.035 in. (0.8/0.9 mm) solid wire, and .030/.035 in. (0.8/0.9 mm) flux-cored wire. Wire feed speed on the product page is 60–650 ipm. |
| Weight | 33 lb. | 38.4 lb on the product page. The spec sheet says the machine weighs under 39 pounds. |
| Material thickness | Steel: 24 ga.–3/16 in. single pass. Aluminum: 18–14 ga. single pass. | Mild steel: MIG/flux-cored 24 ga.–3/8 in., DC TIG 22 ga.–3/16 in., stick 16 ga.–3/8 in. |
Outlet check, Millermatic 142 · Outlet check, Multi-Handler 200