Rebel EMP 215ic vs TIG200

Same fields. Each cell is that model's published text. A blank stays "Not published by manufacturer." The outlet chip does not hide either column.

By the WeldFacts editorial team · Checked 2 November 2026 · How we verify

Spec	Rebel EMP 215ic	TIG200
Process	GMAW (MIG), GTAW (TIG), and SMAW (stick). Flux-cored wire is listed in the wire-diameter table. Source	DC TIG and stick. Source
Output amp range	MIG setting range: 15 A / 14.75 V to 130 A / 20.5 V on 120 V, and to 235 A / 26.0 V on 230 V. TIG: 5 A to 130 A on 120 V and to 200 A on 230 V. Stick: 6 A to 130 A on 120 V and 16 A to 180 A on 230 V. Source	On 240 V: TIG 190 A and stick 185 A. On 120 V: TIG 145 A and stick 140 A. The lower limit is 10 A for either process. Source
Rated duty cycle	MIG, 230 V: 205 A / 24.25 V at 25% and 235 A / 26 V at 15%. MIG, 120 V, 20 A breaker: 130 A / 20.5 V at 20%. TIG, 230 V: 180 A / 17.2 V at 30%. Stick, 230 V: 180 A / 27.2 V at 25%. The table prints more duty points at 40%, 60%, and 100%. Source	Not published by manufacturer Source
Input voltage and plug	120 V or 230 V, 1-phase, 50/60 Hz, ±10%. Imax MIG: 20.8 A on a 15 A breaker and 28.6 A on a 20 A breaker at 120 V; 30 A at 230 V (27.6 A at 25% duty cycle). The installation guide’s maximum recommended time-delay fuse or breaker is 30 A, and the maximum normal fuse is 50 A, for both supply voltages. Input current at maximum output in that guide is 30 A. Source	Dual-voltage 120/240 V input. Input amperes are not in that description. Source
Wire or rod size	Mild steel solid wire .023–.035 in. (0.6–0.9 mm). Stainless solid wire .030–.035 in. (0.8–0.9 mm). Flux-cored wire .030–.045 in. (0.8–1.1 mm). Aluminum .030–3/64 in. (0.8–1.2 mm). Spool size 4–8 in. Source	Not published by manufacturer Source
Weight	42 lb (19.1 kg). Dimensions 23 × 9 × 16 in. Source	Not published by manufacturer Source
Material thickness	Not published by manufacturer Source	7/16-inch steel in a single pass is tied to the 190 A, 240 V TIG sentence. The 10 A floor is described as mild enough for 24-gauge sheet metal. A 120 V thickness is not printed. Source

Outlet check, Rebel EMP 215ic · Outlet check, TIG200