WeldFactsSheet numbers only

Home CompareMillermatic 142 vs Rebel EMP 235ic

Millermatic 142 vs Rebel EMP 235ic

Same fields. Each cell is that model's published text. A blank stays "Not published by manufacturer." The outlet chip does not hide either column.

By · Checked · How we verify

Spec Millermatic 142 Rebel EMP 235ic
Process MIG (GMAW) and flux-cored (FCAW).
Source
 MIG, TIG, and stick. The wire table includes flux-cored diameters in the ordering copy: up to .052 in. cored wire.
Source
Output amp range 30–140 A.
Source
 Current range 5–150 A on 120 V and 5–250 A on 230 V. Maximum output 250 A / 30 V.
Source
Rated duty cycle 100 A at 19 V, 60% duty cycle. 80 A at 18 V, 100% duty cycle.
Source
 At 104°F (40°C): MIG 120 A / 19 V at 40% on 120 V and 235 A / 26 V at 40% on 230 V. Stick 90 A / 23.6 V at 40% on 120 V and 210 A / 28.4 V at 25% on 230 V. TIG 130 A / 15.2 V at 40% on 120 V and 240 A / 19.6 V at 40% on 230 V.
Source
Input voltage and plug 120 V, 20 A, single-phase, 50/60 Hz.
Source
 Primary voltage 120 VAC and 208/230 VAC, 1-phase, 50/60 Hz. Supply range 90–270 VAC. Supply plug 230 V, NEMA 6-50P. A separate accessory is a 230 V to 120 V, 15 A power adapter (W4014000). Input amperes are not in the specifications table.
Source
Wire or rod size Set up for .024–.035 in. (0.6–0.9 mm) solid wire and .030–.045 in. (0.8–1.2 mm) flux-cored wire. Uses 4- or 8-inch spools.
Source
 Mild steel .023–.035 in. (0.6–0.9 mm). Stainless .030–.035 in. (0.8–0.9 mm). Aluminum .030–.045 in. (0.8–1.2 mm). The introduction also says up to .045 in. solid wire, up to .052 in. cored wire, rods up to 5/32 in., and TIG rods up to 3/16 in. Spools 4, 8, and 12 in.
Source
Weight 33 lb.
Source
 Specifications table: 63 lb (28.6 kg). The same brochure’s introduction says “weighing in at 53 lbs. (24 kg).”
Source
Material thickness Steel: 24 ga.–3/16 in. single pass. Aluminum: 18–14 ga. single pass.
Source
 Maximum plate thickness 1/2 in. (12.7 mm).
Source

Outlet check, Millermatic 142 · Outlet check, Rebel EMP 235ic